Maintenance Systems

The general facility maintenance, and electromechanical equipment and other network elements in particular, are supported in the PM (Plant Maintenance) module. This system is integrated into the economic system and the corporate resources monitoring.

With this module (PM), management of maintenance of equipment in the water treatment plants and networks, both preventive and corrective, planned or managed, is achieved.

Its basic functions are:

1. Inventory of computers and technical locations, where the technical characteristics relevant to such equipment are detailed, as well as their hyerarchical location within the installation, additional documentation for consultation, plans, manuals, internal documents, images..., etc.
2. Planning of maintenance tasks and generation of work orders for compliance. The system proposes a calendar of tasks and checks to be performed in each of the equipments. It also allows for planning of maintenance activities from temporal schedules or from meter readings. To this end, the system is connected to the Scada of the installation, from where it receives this information. The scheduler assigns these orders to the maintenance resources available.
3. Recording of the results of the work orders, from where reports of work performed and their results are given to the system. The system allows recording of parameter readings such as hours of operation, temperature, vibration, recorded cubic meters..., etc.
4. Detected incidents recording on site, tracking of these, and preparation of orders of preventive and/or corrective maintenance.
5. Statistics and reports on incidents.

With this system, it is possible to make an accurate and proper monitoring of the tasks performed, besides keeping a historical record of incidences which is of fundamental importance to optimize equipment performance and extend its life span.